リケラボ論文検索は、全国の大学リポジトリにある学位論文・教授論文を一括検索できる論文検索サービスです。

リケラボ 全国の大学リポジトリにある学位論文・教授論文を一括検索するならリケラボ論文検索大学・研究所にある論文を検索できる

リケラボ 全国の大学リポジトリにある学位論文・教授論文を一括検索するならリケラボ論文検索大学・研究所にある論文を検索できる

大学・研究所にある論文を検索できる 「Tangential bond stiffness evaluation of adhesive lap joints by spectral interference of the low-frequency A0 lamb wave」の論文概要。リケラボ論文検索は、全国の大学リポジトリにある学位論文・教授論文を一括検索できる論文検索サービスです。

コピーが完了しました

URLをコピーしました

論文の公開元へ論文の公開元へ
書き出し

Tangential bond stiffness evaluation of adhesive lap joints by spectral interference of the low-frequency A0 lamb wave

Mori, Naoki 大阪大学

2022.03

概要

Transmission spectra of the lowest-order antisymmetric (A0) Lamb wave for adhesively bonded single lap joints are experimentally investigated in a frequency range below 0.4 MHz. Based on the theoretical results of the wave interference, a tangential bond stiffness evaluation method is proposed for the lap joints. Aluminum alloy plates bonded with epoxy adhesive on different conditions were prepared as bonded specimens. An air-coupled ul- trasonic transducer was used to generate the A0 mode in the specimens, and the signals of the transmitted waves across the joints were measured with a pin-type piezoelectric transducer. Spectral analysis was performed for the measured waveforms, and the transmission coefficient was calculated for each specimen as a function of fre- quency. The experimental results showed that the transmission coefficient has local maxima and minima at multiple frequencies, called peak and notch frequencies, respectively. The sets of the peak and notch frequencies were different among the bonded specimens. Based on the peak and notch frequencies, the tangential bond stiffness was estimated for each bonded specimen. As a result, the bond stiffnesses obtained for the specimens with the same nominal bond thickness and adherend pretreatment were almost equal even if the bond lengths were different. Furthermore, the evaluation results showed that pretreatments such as sanding and contami- nation of adherend surfaces affect the bond stiffness due to the change in the interfacial stiffness.

参考文献

[1] Guyott CC, Cawley P, Adams RD. The non-destructive testing of adhesively bonded structure: a review. J Adhes 1986;20:129–59.

[2] Adams RD, Drinkwater BW. Nondestructive testing of adhesively-bonded joints. NDT E Int 1997;30:93–8.

[3] Lavrentyev AI, Rokhlin SI. Determination of elastic moduli, density, attenuation, and thickness of a layer using ultrasonic spectroscopy at two angles. J Acoust Soc Am 1997;102:3467–77.

[4] Baltazar A, Wang L, Xie B, Rokhlin SI. Inverse ultrasonic determination of imperfect interfaces and bulk properties of a layer between two solids. J Acoust Soc Am 2003;114:1424–34.

[5] Mezil S, Bruno F, Raetz S, Laurent J, Royer D, Prada C. Investigation of interfacial stiffnesses of a tri-layer using zero-group velocity Lamb modes. J Acoust Soc Am 2015;138:3202–9.

[6] Siryabe E, R´enier M, Meziane A, Galy J, Castaings M. Apparent anisotropy of adhesive bonds with weak adhesion and non-destructive evaluation of interfacial properties. Ultrasonics 2017;79:34–51.

[7] Seifried R, Jacobs LJ, Qu J. Propagation of guided waves in adhesive bonded components. NDT E Int 2002;35:317–28.

[8] Ren B, Lissenden CJ. Ultrasonic guided wave inspection of adhesive bonds between composite laminates. Int J Adhes Adhes 2013;45:59–68.

[9] Gauthier C, Galy J, Ech-Cherif El-Kettani M, Leduc D, Izbicki JL. Evaluation of epoxy crosslinking using ultrasonic Lamb waves. Int J Adhes Adhes 2018;80:1–6.

[10] Rokhlin SI. Lamb wave interaction with lap-shear adhesive joints: theory and experiment. J Acoust Soc Am 1991;89:2758–65.

[11] Lowe MJS, Challis RE, Chan CW. The transmission of Lamb waves across adhesively bonded lap joints. J Acoust Soc Am 2000;107:1333–45.

[12] Lanza di Scalea F, Rizzo P, Marzani A. Propagation of ultrasonic guided waves in lap-shear adhesive joints: case of incident a0 Lamb wave. J Acoust Soc Am 2004; 115:146–56.

[13] Castaings M. SH ultrasonic guided waves for the evaluation of interfacial adhesion. Ultrasonics 2014;54:1760–75.

[14] Mori N, Kusaka T. Reflection and transmission characteristics of Lamb waves at an adhesive lap joint of plates. J Acoust Soc Am 2019;145:3075–85.

[15] Golub MV, Eremin AA, Shpak AN, Lammering R. Lamb wave scattering, conversion and resonances in an elastic layered waveguide with a surface-bonded rectangular block. Appl Acoust 2019;155:442–52.

[16] Koodalil D, Rajagopal P, Balasubramaniam K. Bond stiffness estimation with shear horizontal guided waves generated using PPM-EMATs. Int J Adhes Adhes 2021; 104:102761.

[17] Jones JP, Whittier JS. Waves at a flexibly bonded interface. J Appl Mech 1964;34: 905–9.

[18] Pilarski A, Rose JL. A transverse-wave ultrasonic oblique-incidence technique for interfacial weakness detection in adhesive bonds. J Appl Phys 1988;63:300–7.

[19] Mori N, Matsuda N, Kusaka T. Effect of interfacial adhesion on the ultrasonic interaction with adhesive joints: a theoretical study using spring-type interfaces. J Acoust Soc Am 2019;145:3541–50.

[20] Rose JL. Ultrasonic waves in solid media. Cambridge: Cambridge University Press; 1999.

[21] Dixon S, Edwards C, Palmer SB, Reed J. Considerations for the ultrasonic inspection of metal-adhesive bonds using EMATs. J Nondestr Eval 2000;19: 95–103.

[22] Matsuda N, Mori N, Furuta Y, Nishikawa M, Hojo M, Kusaka T. Evaluation of interfacial characteristics of adhesive joints by ultrasonic reflection technique. Proc Meet Acoust 2019:065012.

参考文献をもっと見る

全国の大学の
卒論・修論・学位論文

一発検索!

この論文の関連論文を見る